TC ELECTRONIC G-FORCE
Manual de Usuario

THE BLOCKS
Tempo The Tempo parameter sets the relationship to the global Tempo e.g. if you set it to 1/4T you will get quarter note triplets of the tapped tempo. 1/4 equals the BPM (tapped Tempo). If you select �Ignored� the current parameter will use the Preset value and will not be affected by the Global Tempo. Depth Will set the intensity of the Tremolo, or how deep it sweeps. Curve (only in Advanced) Sets the curve of the LFO. Choose between: Square, Sine, or Triangle. The most common LFO curve in Tremolo is Triangle. Out Level Controls the output level of the block. Mute mode See Mute mode in the introduction of this chapter.

Panner

Speed Controls the speed of the Panner. The simple Panner always pans fully left and right. Tempo The Tempo parameter sets the relationship to the global Tempo e.g. if you set it to 1/4T you will get quarter note triplets of the tapped tempo. 1/4 equals the BPM (tapped

Square Triangle Sine

Tempo). If you select �Ignored� the current parameter will use the Preset value and will not be affected by the Global Tempo. Curve (only in Advanced) Sets the curve of the LFO. Choose between: Square, Sine, or Triangle. The most commonly used curve in Panning is Sine. Pulsewidth (only in Surround Panner) Controls the division of the left and right part of the current waveform, i.e. if Pulsewidth is set to 75%, left channel will be on for 75% of the time. (see pulsewidth figure in Tremolo). LFO Phase (only in Surround Panner) An LFO phase change causes a small delay in one of the waveform starting points. This means that left and right outputs start the current waveform at two different points. Example: If LFO phase is set 180º, left and right will be exactly opposite.

Try the Square waveform with 100% Depth, to get holes in your guitar sound (called Transforming). Pulsewidth (only in Advanced) Controls the division of the upper and lower part of the current waveform, e.g. if Pulsewidth is set to 75%, the upper half of the waveform will be on for 75% of the time. Pulsewidth LFO Phase (only in Advanced) An LFO phase change causes a small delay in one of the waveform starting points. This means that left and right outputs start the current waveform at two different points. Example: If LFO phase is set 180º, left and right will be exactly opposite. Mix Mix between direct sound and effect. In Level Controls the input level of the block.

90 phas change LFO PHASE Pan Center Using this parameter, you can move the center of the Panner. NOTE: Large increments of the Pan Center, in combination with a broad Depth will cause the Panner to pan beyond a normal stereo image. 37